It has been built for a Duratec 2.5L so you will see in the pictures it has the Duratec bell housing fitted, however it can be sold without this if needed for a different engine.
Clutch shaft is 1”x23 spline – please contact for full measurements
Please see below full details:
ST82-14 Gearbox with oil pump – 14/34, 19/34, 23/32, 24/28, 24/24, 23/20, final drive 12×58
Slave cylinder 54mm / 12mm spacer
Ramp angles 35/60-(35/90) 120Nm preload
Reverse release cable 1500mm
Additional accessories if required:
x2 Tripod kits complete with rubber boot & fittings
x1 Duratec bell housing
x1 SADEV gear lever
Leave a Comment
You must be logged in to post a comment.